3
SAFETY INSTRUCTIONS
Keep this manual in a visible location near the unit for easy reference.
Use a circuit breaker for the capacity.
(It may cause fire and electric shock)
Do not use a damaged power cable.
(Short, fire or shock hazard)
Before cleaning, disconnect the unit.
(Otherwise risk of electric shock)
Do not place anything on top of the machine.
(This could cause electric shock, malfunction or injury)
Do not use an extension lead unless of the approved type.
(Risk of fire and / or electric shock)
Do not ‘kink’ or sharply bend the power cable nor put any weight on it.
(The insulation may be damaged causing fire or electric shock)
Turn off control panel after turn off circuit breaker first.
(Risk of electric shock and / or malfunction)
Do not use this unit on unstable or inclined surfaces. Always use
on solid flat floor. (Risk of falling causing injury, fire or malfunction)
Do not use the unit in explosive environments or in areas where flammable gas
leakage may occur.
Unlock the casters and push the unit to a flat, level surface and set the caster brakes to the locked position.
If the power cord or plug is damaged, repair should only be performed by qualified
electrical personnel.
Do not connect/disconnect the power cord or attempt to operate buttons with wet hands.
This could result in electrical shock.
Do not use the unit in a corrosive atmosphere.
Do not install the unit on uneven or sloping surface. The unit may roll or topple over
even if the casters are set to the locked position.
Do not use the unit in areas where it will be exposed to rain or water.
WARNINGS REGARDING PROPER LOCATION FOR INSTALLATION
MOVING THE UNIT
Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present, wipe off
with a clean, dry cloth.
Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact a qualified repair technician or a qualified electrician to perform
replacement or repair of the power cord, plug or prongs.
PLUGGING IN THE UNIT
The following symbols are for your guidance:
= You must NOT.
= You MUST.
WARNING
INSTALLATION