1.
Optionally, 4 pieces nuts of 2 different metric values are used for the product connection.
(Torque: M6-
6
lb ft
, M8-
14,7 lb ft
)
2.
Optionally, 4 pieces bolts of 2 different are used for the product connection. The system
which is shown in the figure of 2 is mounted to using M6/M8 bolts with the help of a wrench.
(Torque: M6-
6
lb ft
, M8-
14,7 lb ft
)
3.
For the electrical connection, the pins on the connectors fit together and are installed by
paying attention to the markings on the connector. Locking of the connectors is made by
rotating. The cable coming from connector is connected to junction box.
Note1: Electrical connection can be made using with sleeve, too instead of connector.
To maintain
of
the driver;
4.
The electrical connection of product is disconnected. The connector is unlocked by turning it
counterclockwise.
5.
2 Pieces round head bolts that connect the control unit to the body are removed.
6.
he system is taken out by removing the 4 pieces M4 round head bolts on the cover on the
cable outlet side of the control unit. (Torque:
1,8 lb ft
)
7.
The cables connected to the driver, 4 pieces M4 cross-slotted bolts and 4 pieces nuts are
removed and the driver is pulled out. (Torque:
1,8 lb ft
)
For the location of the light source;
8.
The layout of the 40L0S is provided for the TF type lens to provide asymmetrical light
distribution. The red arrow indicates the "Lighting Direction".
9.
The layout of the 20U20D is provided for the ME type lens to provide asymmetrical light
distribution. The red arrow indicates the "Lighting Direction".
10.
The layout of the 20U20D is provided for the DWC type lens to provide asymmetrical
light distribution. The red arrow indicates the "Lighting Direction".
11.
The layout of the 40U0D is provided for the ME type lens to provide asymmetrical light
distribution. The red arrow indicates the "Lighting Direction".
12.
The layout of the 40U0D is provided for the DWC type lens to provide asymmetrical light
distribution. The red arrow indicates the "Lighting Direction".
To change the LED lighting module;
The light source inside this luminaire must only be replaced by the manufacturer or its
authorized service or an equivalent qualified person.
ASSEMBLY INSTRUCTIONS
To assemble
of
the luminaire to steel floor;
English
WARNINGS AND REMARKS FOR INSTALLATION
AND MAINTENANCE
Safety Instructions
•
The light source contained in this luminaire shall only be replaced by the manufacturer or his
service agent or a similar qualified person. Always switch off the power prior to installation,
maintenance or repair activities.
•
The manufacturer is then discharged from liability when damage is caused by improper use or
installation.
•
•
If any luminaire is subsequently modified, the persons responsible for the modification shall be
considered as manufacturer.
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling
parts, cuts, abrasions and other hazards, please read all warnings and instructions included
with the luminaire, on the luminaire’s packaging and affixed to the luminaire itself..
Installatio
n
•
•
LEDs are high-quality electronic components! Please avoid contacting the light output opening
of the LED directly during installation or relamping.
IMPORTANT
To ensure secure connection, the luminaire housing must be positioned precisely in relation to
the mounting plate.
Cleaning And Maintenance
•
Clean luminaire regularly with solvent-free cleaners from dirt. Please do not do not clean the
luminaire with using high-pressure liquids.
