3
913-789-9590
www.hepacart.com
Version: 2022.2
SEQUENCE OF OPERATIONS
Setup
1.
Position HEPACART® AnteRoom into place in front
of the room to be isolated with the unit in a vertical
position. Take care when rotating unit from
horizontal to vertical orientation. Watch for ceiling
clearance and for ceiling mounted devices such as
signs, sprinkler heads, etc.
2.
Once vertical attach any HEPACART® AnteRoom
extenders or reducers as required to accommodate
the door frame. See the chart on page 4 below.
3.
Maneuver the HEPACART® AnteRoom towards the
opening such that the magnetic back is aligned with
the door frame. Once the unit is close enough the
magnets will attach the HEPACART® AnteRoom
tightly to the door frame.
4.
In each of the (4) four corners of the floor there are
(4) four floor levelers. Turn these clockwise or
counter-clockwise to provide even pressure on the
floor.
a.
HCAR36 models have two stabilizer brackets that
should be attached and lowered to the floor at
this time.
b.
Attach both ramps to the HEPACART®
AnteRoom.
5.
Decide which side of the HEPACART® AnteRoom
you would like to attach the negative air machine
flex hose and slide the duct adapter into place.
a.
Slide the shut-off plate into the opposite
side to seal opening.
6.
Attach negative air machine (sold separately) to
HEPACART® AnteRoom using flex hose and clamps.
7.
Turn on negative air machine (sold separately) and
set to the desired speed.
8.
The HEPACART® AnteRoom is now ready for use as
an isolated vestibule.
Takedown
1.
Once project is complete. Clean the HEPACART®
AnteRoom thoroughly.
a.
Vacuum up debris.
b.
Wipe down all surfaces.
2.
Turn off the negative air machine and detach flex
hose from the AnteRoom duct adapter.
a.
For HCAR36 models remove stabilizer brackets at
this time.
3.
Gently pull HEPACART® AnteRoom away from the
door frame until magnetic seal is disengaged.
4.
Remove extenders and reducers.
a.
If the AnteRoom is being moved to a similar
doorway nearby extenders and reducers can
remain in place.
5.
Using the HEPACART® AnteRoom Mobility kit or a
wheeled platform, tilt the AnteRoom to the
horizontal position so it can be wheeled to the next
location. Take care when rotating unit from
horizontal to vertical orientation. Watch for ceiling
clearance and for ceiling mounted devices such as
signs, sprinkler heads, etc.
6.
Move HEPACART® AnteRoom to the next location
and repeat setup.
