External Device Control
The HEOS Link can tightly integrate with most Denon AVR, Preamps, and
Hi-Fi systems to allow them to operate as if they were one device.
You can configure your HEOS Link to tell the connected device when to
turn on, turn off, select the correct input and adjust volume and mute.
You can adjust specific settings for each of your HEOS Links in your
system:
1
Select the Settings
a
icon located in the upper left
corner of the main Music menu to display the Settings
menu.
2
Select “My Devices” to display a list of your devices.
3
Select a HEOS Link.
4
Select “Control”.
5
Select the method which is most appropriate for your
configuration:
o
IP Control
IP Control is available for Denon AV receiver models sold after 2010 which
are connected to the same network as the HEOS Link and Controller
devices.
1
Select IP.
2
Select the AVR that you have your HEOS Link
connected to.
3
Select the input on the AVR that you have your HEOS
Link connected to.
4
Select Done.
NOTE
You can test the connection to the AVR by pressing the power on, off, and input
buttons.
0
The following settings are forced to change when IP Control is set.
0
Line Out Level: Fixed
Contents
Setup
Use
Troubleshooting
Status LED
Appendix
40
