SETTING UP THE
5513F20
1)
Read this entire instruction before beginning set-up.
It is best to have three installers working together on lifting
portions of this fountain setup. Prepare a suitable location
for your new fountain. Set the three 7098 Plinth
Bottom Platforms in the center of your site.
Because this is a tall fountain, care must be given
to make sure the platforms are entirely level in
order to ensure proper water flow
.
2) Notice in the drawing at the right that both the
sets of 7098 platforms and 7097 Pedestal Segments
contain three pieces. Decide now if you will want
to line them up – one pedestal segment on each
platform - or if you want to overlap the pedestal
segments, covering the seams between platforms.
The latter is recommended for stability. Make
sure that the platforms are oriented to support
your most likely viewing angle
.
3) Set the three 7097 segments on the inside ring of
the platform sections. (
There is a slight depression
in the platform sections which properly locates the
pedestal segments
.) Level the pedestal segments if needed.
4) Place the 6098 Large Fiberglass Bowl on
the pedestal segments. Check to
make sure the stand pipe is tight.
5) Set the pump in the bowl and slide its
power cord down through the stand pipe
and out the bottom. (
This may mean that
you do not push one of the pedestal segments
all the way in until the pump cord is
pulled out the bottom. Make sure to pull
the cord out on the side nearest your power
supply.
) Open the slit to the largest hole in
the three-hole stopper, place around the
pump cord, close the slit, and push the
stopper into the top of the stand pipe. The
extra holes in the stopper are provided in
case you wish to add lights to your fountain.
Use the corks provided to plug any unused
holes in the stopper.
6) Thread the larger Barbed Adapter into the pump
exhaust opening. Connect the longest Tube to its barb and clamp
.
7) Place and center the 7001 Pedestal in the bowl, around the pump and tube. Then set the 7715
Pedestal on the 7001.
Make sure to place your fountain on a firm area
which will not settle. Note: Always follow local
electrical codes and use a 110V GFCI protected
outlet. Do not let children climb on fountain.
