6) Thread the other adapter into the top
of the pump. Loosen and slip the clamps
onto the tube. Then push the open ends
of the tube onto both barbed adapters and
tighten the clamps on both ends.
7) Set the 6006A and 6006B cover
pieces on the basin. Then set the first of
fourteen stone segments on the internal
riser. Make sure it is level.
8) Place one of the 1” plastic tube rings
on the first segment and place another
stone segment on the tube ring. Repeat
several times. Prior to the eighth stone
segment, roll another of the o-rings down
the 4” tube, stopping where the next
stone segment will stop. Then install the
eighth segment down the 4” tube and
over the o-ring. (This will keep most of
the water from falling down on the inside,
rather than the outside, of the stone
segments.) Repeat the stacking until the
last segment, which should again be
installed over an o-ring to direct the
water outward.
9) Read your pump and light instructions.
Fill the basin with water. Then plug in the
pump and connect to the light transformer
to enjoy your fountain. Use your light kit
fob to select the light display you prefer.
If the pump does not immediately begin
working, there may be an “airlock”
within the impeller chamber. Simply
unplug and plug in a few times
and it starts.
csd 2
2/2020
IMPORTANT – WINTER CARE
Winter ice build-up can cause damage to concrete statuary. Follow
these tips to reduce winter weathering to your fountain:
* Disconnect power to pumps and lights.
* Remove plugs/stoppers in all fountain bowls to open drains and let
all moisture out. Keep drains open throughout winter.
* Cover with a Henri fountain cover. Keep tight and do not let snow
or water collect in sagging areas.
* Do not allow snow or ice to build up on or against the concrete.
Remove snow before it turns to ice. Do not use antifreeze, salt or
chemical ice removers as these may damage concrete.
Online Resources
Products
:
www.henristudio.com/products
FAQs:
www.henristudio.com/faq
Warranty:
www.henristudio.com/warranty
Contact :
www.henristudio.com/contact-us
Caution: The use of Chlorine or Chlorine Bleach or water
coloring additives may damage the finish of your fountain.
