Henrac Tech Ef168, Operating Manual, Page: 8 / 11

5
Receiver button and function:
1.Long press for ON/OFF
2. Setting function of receiver collar: the first level is only
vibration function, the second level is weak static shock function,
the third level is strong static shock function. (There is a warning
beeper prompt for each level.) 1). It’s with function vib
beeper when the collar ON and the light on receiver collar
flashing continuously one time; 2). It’s with function weak shock
and beeper when press twice ON button and the light on receiver
collar flashing continuously two times; 3). It’s with function strong
shock and beeper when press three times ON button and the light
on receiver collar flashing continuously three times; 4). if you
continue press ON button, the collar will cycle function.
3. If receiver collar is flashing light red(.0.5S flashing one
time), it’s with low battery, and now you need charge for it.
Place the collar around the dog’s neck with the receiver box
under the chin. The collar must be on relatively tight to keep the
probes making shin contact without restricting breathing. You
should be able to slide only one finger under the strap at the back
of dog’s neck. Please check the skin of the dog’s neck every day,
if the dog’s neck has any adverse reactions, you must stop use
this collar on dogs’ neck.
If the erythema is caused by too long wearing time or too
tight collar, it needs to use it after recovery.
Notice: always make sure the collar is functioning properly
before putting it on the dog.
6.Put the receiver collar on your dogs
Notice: Don’t place the receiver collar on your dog until the
fencing system has been tested and the signal field adjusted. You
must manually test the containment system to verify that the
signal is properly transmitted trough the wire. Use the supplied
test light.