Henny Penny Velocity OXE-100, Operation Manuals

Page: 55 / 118

Maintenance
43
4 4))
Insert the drain pan under the unit until it latches.
5 5))
Manually fill the vat, by pouring oil from a container, to the lower limit line with new oil.
6 6))
Power on the unit and return to normal operation.
7 7..6 6..4 4..8 8 F Fiillll tth he e V Va att ffrro om m B Bu ullkk
Fill the vat with new oil by doing the following:
1 1))
Press the n ne exxtt► ► button. EXIT DISPOSE? and YES NO displays.
2 2))
Press the Y YE ES S button. CLOSING... and then - OFF - displays.
3 3))
Remove, clean and dry the drain pan and install a new filter. Refer to 3.2 Drain Pan Assembly,
page 10 for instructions.
4 4))
Insert the drain pan under the unit until it latches.
5 5))
Press the A Ad dd d < <-- N Ne ew w button until the oil reaches the lower limit line with new oil.
6 6))
Power on the unit and return to normal operation.
7 7..7 7 C Clle ea an n--O Ou utt M Mo od de e
After the initial installation of the fryer and during every oil change, the vat must be thoroughly
cleaned. There are two ways to clean the vat using the clean-out mode, heated and cold soak.
Operators can fill the vat with warm water and cleaning solution, enable heat, and then scrub the vat
immediately (P.M.) or let it soak overnight cold and scrub it in the morning (A.M.). Cleaning the vat
immediately is called a Heated Clean-Out and allowing the vat to soak overnight is called a Cold-
Soak Clean-Out. The choice of which type of clean-out an operator uses is set during installation
within the software settings. Refer to Drain and dispose of the oil before performing these
procedures. Refer to
7.6
Oil Disposal, page 36
for instructions.