Henny Penny LVG-202, Technical Manual, Page: 55 / 174

Maintenance
47
NOTICE
Excess force will damage temperature probe.
1 10 0))
Locate temperature probe through pot wall.
1 11 1))
Place gauge against pot wall as shows in Figure 7-1 Probe Assembly Install,
page 47 .
Figure 7-1 Probe Assembly Install
1 12 2))
Push temperature probe through until it makes contact with gauge.
1 13 3))
Tighten temperature probe in place.
C CA AU UT TIIO ON N!! E Exxcce essss ffo orrcce e w wiillll d da am ma ag ge e tte em mp pe erra attu urre e p prro ob be e.. H Ha an nd d--ttiig gh htte en n n nu utt a an nd d
tth he en n 1 1//2 2 ttu urrn n w wiitth h a a w wrre en ncch h..
1 14 4))
Connect new temperature probe to the connector and fasten connector onto
control panel.
1 15 5))
Replace control panel and reconnect power to vat.
1 16 6))
Fill vat by pressing and holding the filter button until *FILTER* *MENU* shows in
the display. Then once “1.EXPRESS FILTER” shows in the display, press ►4
times until “5.FILL FROM PAN” shows in the display. Press ✓ button and
“PUMP” “EXIT” shows in the display. Press √ button again, and oil fills vat. Once
vat is full, press X
X twice to return to normal operation.
7 7..1 11 1 B Ba acckk S Sh hrro ou ud d R Re em mo ovva all
1 1))
Using a crosshead screwdriver, loosen the four screws on the lower shroud.
2 2))
Remove shroud and set aside to access all back components.