5
Sept. 2013
2-1.
TRoUBLE
SHooTInG GUIDE
(ConT.)
Problem
Cause
Correction
Oil foaming or boiling
over top of vat
•
Water in oil
•
Improper or bad oil
• Improper filtering
•
Improper rinsing after
cleaning the vat
•
drain and clean oil
•
use recommended oil
• Refer to filtering procedures
•
Clean and rinse vat and then dry thor-
oughly
Oil will not drain from vat
•
drain valve clogged with
crumbs
•
drain trough clogged
•
Open valve, force cleaning brush
through drain
•
Remove right side panel and remove
plug from end of trough and clean trough
Filter motor runs but
pumps oil slowly
•
Filter line connections
loose
•
Filter paper or pad
clogged
•
Filter not reassembled
correctly
• Tighten all filter line connections
• Change filter paper or pad
•
Refer to assembly instructions on inside
door
bubbles in oil during en-
tire filtering process
•
Filter pan not completely
engaged
•
Filter pan clogged
• Damaged O-ring on filter
line receiver on fryer
• Make sure filter pan return line is pushed
completely into the receiver on the fryer
•
Clean pan and change paper or pad
•
Change O-ring
Filter motor will not run
•
The thermal reset button
on the rear of the pump
motor is tripped
•
Remove the right side panel and
allow time for the motor to cool and
then, using a screwdriver, press hard
against the button until it clicks
To prevent burns caused
by splashing shortening,
turn the unit’s PoWER
switch to the oFF position
before resetting the filter
pump motor’s manual
reset
protection device.
