16 •
Important: Always read and follow the on-screen operating instructions.
Video Balancer
Machine Self-Test -
Provides software version,
technical, and other machine diagnostic informa-
tion (DIAGNOSTIC PROCEDURES section page
34).
Static Unbalance Displayed -
Toggles the display of
the Static-on-Screen™ value ON or OFF.
Set to ON.
Stop On Top -
Toggle ON or OFF to automatically
stop the wheel near TDC (top-dead-center) for
outer weight placement.
Set to OFF.
Machine Self-calibration -
Calibrates the weight
amount and placement. See MACHINE SELF-CAL-
IBRATION AND SERVICE ADJUSTMENTS on page
26 for more information.
Additional Functions
Press the
key and select the CYCLE HISTORY
option
for the following menu.
Figure 27 - Cycle History Screen
Cycle History -
Select option
to set the
number of spins between calibrations (500 - 5000
@ 500 spin increments).
Also, the operator can view the following information
when the CYCLE HISTORY option
is selected.
• The number of daily spins that is automatically
reset after switching the machine off.
• View the number of spins since calibration.
• View the total number of spins.
A
Ad
dv
va
an
nc
ce
ed
d B
Ba
alla
an
nc
ciin
ng
g
F
Fu
un
nc
ct
tiio
on
ns
s
This wheel balancer enables you to balance a variety
of wheel configurations. Read through this section, it
will help you determine which mode and options are
best suited for certain wheel assemblies.
Remember:
As with any balancing procedure, first
remove any weights attached to the wheel, inspect the
tire and wheel, and use the most appropriate balancer
mounting method before beginning.
Initial Screen Options
At the initial screen (see page 11), press the num-
bered key that corresponds with the key icon along the
bottom of the video display screen for the following
options.
Mode -
select from several balancing types and
weight placement locations.
Figure 28 - Modes Screen
Dynamic -
the “initial screen” is a dynamic bal-
ance mode using two clip-on weight locations.
Note:
To reset the mode back to the initial screen at
any time, press the DYNAMIC option
, or turn the
machine OFF then ON. Note that if an operator is in a
balance mode, it may be necessary to finish the bal-
ance cycle first.
DIM -
(available in 3D view) select to enter dimen-
sions manually. See MANUALLY SETTING
WHEEL DIMENSIONS on page 23 for further
details.
3
2
2
1
3
1
3
3
MENU
6
5
4
3
Shown with Recommended Settings
