6.
Parameter display
This display shows the current value of the active function during the program cycle or the
set value of the selected function when the machine is inactive. A red dot will light up in the
bottom right if the option is enabled.
7.
Function display
The LED light in front of the function lights up if the function is active during the program cycle
or if the function is selected in the programming mode.
8.
– / STOP button
This is used to interrupt the entire cycle during a packaging cycle. All functions are skipped
and the cycle is terminated. In the programming mode, the value of the selected parameter
can be lowered using this button.
9.
+ / VACUUM STOP button
This stops the active function and proceeds to the next program step. In the programming
mode, the value of the selected parameter can be increased using this button.
10. Vacuum meter
Shows the pressure in the vacuum chamber. A value of -1 bar corresponds to 99% vacuum.
11. On/Off button
Serves to turn the control panel on or off.
6.1.2 Starting the Machine
1.
Plug in the machine.
2.
Press the on/off button on the control panel to enable the operation.
3 dashes may be shown on the display during the first start-up or ventilation. This means that the
machine needs to be decompressed. In this case, open the lid to decompress the machine.
6.1.3 Starting the Packaging Cycle
The machine must be started in accordance with Starting the Machine on page 24 before
starting a packaging cycle.
1.
Select the desired program.
Press the PROG 0 – 9 button
2.
Put the product/products in place.
a.
Put the product/products in the vacuum bag.
b.
Place the vacuum bag in/on the vacuum chamber. Make sure the opening(s) is/are
correctly placed with regard to the seal position(s).
3.
Close the lid.
The packaging cycle will start.
6.1.4 Proceeding to the Next Step in the Cycle
For some products, it may be necessary to proceed to the next step in the packaging cycle before
the vacuum time or the vacuum level has been reached.
1.
Proceed to the next step in the cycle.
Press the + / VACUUM STOP button.
The next step will be started.
Operation 24