16/44
Information on this product
Hengst Filtration GmbH
, OPM II, RE 51460-B/04.2021
If an alarm is pending, this display is illuminated in red.
In the online particle monitor, two alarms can be programmed; in this connection
see chapter 9.3.2 "Configuring alarms".
This connection is used to plug in the plug-in power supply unit, the control cable or
the Y distributor. The Y distributor is necessary if a plug-in power supply unit and an
USB CAN adapter are to be connected at the same time.
More information on the accessories for the online particle monitor is contained
in data sheet 51460, see chapter 1.2 "Required and amending documentation".
The following keys are used for the entire operation and programming within the
menus shown in the display:
Using this key, you can select menu entries, open submenus, confirm entries and go
to the next figure in an entry field.
Using this key, you can call the main menu from the measured value display, move
the marking downwards and reduce a figure in an entry field.
Using this key, you can call the main menu from the measured value display, move
the marking upwards and increase a figure in an entry field.
Using this key, you can move one menu level up, quit the main menu and cancel
the entry.
5.3 Product identification
Fig. 5: Name plate
ALARM indicator light (4)
Electrical connection (9)
ENTER key
(7)
DOWN key
(8)
UP key
(10)
ESCAPE key
(11)
