Hendi 970362, Instructions Manual, Page: 5 / 36

5
EN
Technical specification
The vacuum packing appliance Profi Line are ONLY suitable for use with embossed (patterned) bags.
Bags which are completely smooth cannot be used with this appliance.
The recommended thickness of the bags is 100 μm.
Item no 970362 970430 970447
Sealing strip 350 mm 400 mm 500 mm
Vacuum pump 20 l/min 20 l/min 40 l/min
Power 150 W 270 W 350 W
Current 230 V 230 V 230 V
Dimensions 320x280x(H)170 mm 420x280x(H)170 mm 520x280x(H)170 mm
Weight 8 kg 9 kg 12 kg
REMARK: Technical specification is subjected to change without prior notification.
Operation of the vacuum appliance
• Connect the appliance to a 230 V outlet with
ground.
• Switch the appliance on using the main button
located on the right side of the appliance. A digit
from 1 to 9 will be displayed indicating the set
vacuum level (the lower the digit the weaker the
vacuum).
• Then the digit will disappear and one red line will
appear next to the “MAN” label.
• The appliance is ready to operate in manual
mode.
NOTE:
Appliance is not intended for continuous
operation.
The best way to adjust the digital panel: 9 different
levels of vacuum have been programmed in the ap-
pliance. Each of them is 6 seconds long. The level
must be selected according to the size of the bag.
For example:
• Level 3 (18/19 seconds) for bags with a maximum
size of 300 x 400 mm
• Levels 4 and 5 for larger bags with a maximum
size of 400 x 500 mm
• Level 8/9 creating a vacuum in external
containers
Manual mode
• Put the food product into the bag.
• Lift the lid of the packing appliance.
• Place the bag on the heating strip with the em-
bossed side facing down. The bag should not go
beyond the limiting strip (the metal ridge).
• Close the top lid of the appliance.
• Push the START/STOP button shortly at the same
time pressing down the top lid of the appliance
where it is marked PUSH. This increases the
tightness of the lid.
• The appliance’s pump is switched on, while the
display shows the letter “A”
• Observe the bag from which air is removed.
• When the desired vacuum level has been
reached, push the SET/SEAL button – the heating
strip is activated while the display shows num-
bers (countdown of heating time).
• When the manometer shows the minimum value,
you can easily open the lid of the appliance.
• The pump operation time in this mode cannot be
regulated.
• When you push the START/STOP button during
operation of the pump the bag will not be sealed
and the vacuum will be released.