Range of Motion Hinge Stop Application
© 2017 W
eber Orthopedics Inc.
DBA
Hely & W
eber all rights reserved
1185 E Main St., Santa Paula, California 93060 California: 800-221-5465, National: 800-654-3241 International: 805-525-4244, fax: 805-933-2348 U.S. fax: 800-559-5975, www
.hely-weber
.com
C
P
MDSS GmbH, Schif
fgraben 41
30175 Hannover
, Germany
Rev B 4/16
1. Use the included hex wrench to remove the existing
hinge stops by removing the screws.
1.
2. Choose the hinge stops with the desired degrees of extension and flexion. Install the extension stop on the
extension stop side of the hinge, and the flexion stop on the flexion stop side of the hinge.
Tighten the screws so
they are secure but not tight. If the hinges do not move freely loosen the screws.
2.
3. Completed application.
Both medial and lateral hinges must be set to the same extension and flexion.
3.
E0 F100
E10 F90
E20 F80
E30 F70
E40 F60
E50 F50
F10
F0
HINGE ST
OP
FINDER
Hinge stops shown below are included for Flexion (F) and Extension (E) Place hinge stop on chart to verify size
Each stop has two numbers on the front for the degree of flexion (F) or the degree of extension (E)
based on which side of the hinge the stop is used.
EXTENSION ST
OP
SIDE
FLEXION ST
OP
SIDE