Start the Inclusion Mode from the gateway/controller.
To start the inclusion process on the HE-TPS05, simultaneously press the two upper touch buttons (see Figure 8) and hold them for
three seconds.
All buttons will then sequentially blink ‘blue-red’.
If the inclusion has been successful, all buttons will turn blue for three seconds.
If the inclusion was not successful, all buttons will turn red for three seconds. In that case repeat the inclusion process.
Start the Exclusion Mode from the gateway/controller.
To start the exclusion process on the HE-TPS05, simultaneously press the two upper touch buttons (see Figure 8) and hold them for
three seconds.
All buttons will sequentially blink blue-red.
If the exclusion has been successful, all buttons will turn red for three seconds.
If the exclusion was not successful, all buttons will turn blue for three seconds. In that case repeat the exclusion process.
Note:
If the HE-TPS05 has previously been part of a Z-Wave network and not Excluded since, Inclusion is not possible without first
performing an Exclusion or Factory Reset procedure.
Including the HE-TPS05 to an Existing Z-Wave Network
To add the HE-TPS05 to an existing Z-Wave network (i.e. “inclusion”), do the following:
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
Removing the HE-TPS05 from Z-Wave network
To remove the HE-TPS05 from a Z-Wave network (i.e. “Exclusion”), do the following:
Summary of Contents for QUINTO HE-TPS05
Page 1: ...QUICK START GUIDE Touch Panel Switch Quinto HE TPS05 ...
Page 4: ...H E T P S 0 5 ...
Page 5: ...Inclusion or Exclusion Reset 5 6 7 8 ...
Page 6: ...9 10 11 12 ...
