INSTALLATION AND OPERATING INSTRUCTIONS
72-0106 01-07-16
7013482 314 SKSM 215 A
Page 7
Shower
Sauna (10 - 15 min.)
Shower or swim
Rest (10 - 15 min.)
Relax with juice or water
You liked it?
Do it once again and
you will feel great.
SECTION 8: HIGH LIMIT CONTROL (RESET BUTTON)
SECTION 9: HOW TO TAKE A SAUNA
SECTION 7: OPERATION, Continued
The sauna heater has a built-in high limit control, which automatically turns off
the heater if the temperature inside in the sauna room rises to an abnormally high
level.
To restart the heater, let the heater cool, then push the reset button on the bottom
of the heater, see Diagram 1. If the high limit continually shuts off the heater, refer
to Section 14 for Troubleshooting.
• When taking a sauna, allow time to relax completely.
• Remove clothing and jewelry...if required, wear a towel loosely.
• After 10 minutes or when perspiration begins, leave sauna and relax in
dressing area...follow with a cool shower.
• Cooling time should equal time spent in sauna. Enter sauna room again
and stay 5 or 10 minutes.
• Repeat the cycle 2 or 3 times; end with a brisk shower...rinse in cool
water.
• Dress when completely dry and perspiration has stopped.
• Some sauna bathers enjoy the soothing effect of steam by splashing
water on the heated sauna rocks. Use only one dipper full (approx. ½
cup) at a time and keep clear of the steam as it rises off the rocks.
• Do not smoke, exercise or drink alcoholic beverages in the sauna room.
• Do not pour chlorinated pool or spa water on the heater or corrosion
damage may result.
START HEAT IMMEDIATELY:
Start the heater on by pressing the On/Off button. The latest temperature and
usage time settings will remain preset. A green indicator light will come on in area
(B) to indicate that the device has been switched on.
You may switch the system off before the usage time ends by pressing the same
button again. The indicator light will go out.
TIME DELAY START TIME: The control may be set to delay start mode to activate
the heater after a preset amount of time. Select the clock symbol using the
function button (F). Use the – and + buttons to select the amount of hours (1–10
hours) after which the device will switch on. Activate a later start by pressing the
Start button (C).
The timer symbol light will come on (in eld B) and the selected time-lapse
indicator light will start ashing. The ashing indicator measures and indicates the
time leading up to the device being switched on. When the heater starts, the
control panel will automatically show the set temperature.
