9
Control panel Digi II
Program and activate the
memory buttons
The digital control panel has four
memory buttons. As a user you have
the opportunity to set four separate
sauna bath programs. Each program
has its owns adjustments, and you
activate them with just a push of a
button.
When the control panel is delivered
from the factory the memory buttons
are pre-set. It is a good idea, however,
to change the settings so that you get
the sauna bath of your choice. Set the
temperature and duration of the sauna
heater according to earlier instructions
(see page 10).
The preset values of the memory
buttons are:
Duration:
Two hours
Temperature:
Button 1: 60
O
C
Button 2: 70
O
C
Button 3: 80
O
C
Button 4: 90
O
C
Program a
memory button
1. Enter a duration on the control
panel
2. Enter a temperature on the
control panel
3. Push one of the memory
buttons
4. Push the button
prog ok
Activate a memory
button
1. Start the control panel with the
On/Off
button
2. Push one of the memory buttons
Check a memory
button
1. Make sure that the control panel
is in Off-mode. The display is
not lighted.
2. Push a memory button and read
the settings. The display is
lighted.
Memory
buttons
