INSTRUCTIONS FOR INSTALLATION AND USE
CONTROL PANEL 1410-33-1519 or 1410-33-1919
Sensor OLET 6-1
1. Temperature limiter reset button
INSTALLING THE CONTROL PANEL AND SENSOR
The control panel is installed outside the sauna room. The provided sensor is mounted on the sauna room wall,
directly
above the sauna heater, 40 mm from the ceiling. Failure to follow the given installation instructions will cause fire
hazard.
TEMPERATURE LIMITER
The sensor's temperature limiter will cut off the sauna heater's power if the sauna heater's temperature rises
to a level that could be dangerous to the wooden parts. After the temperature has decreased, the limiter may be
reset with the reset button
found at the end of the sensor. The reset hole membrane must be punctured first.
Find the reason for the temperature limiter's triggering before resetting it.
SAUNA THERMOSTAT
Turn the sauna thermostat clockwise to increase the temperature. The easiest way to find the desired sauna room
temperature
is to turn the thermostat to maximum setting and then let the temperature rise to the desired level. Next,
turn the thermostat down until it switches off and keep it in that position. If you need to adjust the setting,
turn the thermostat a little at a time and monitor the effect.
Installation
X) The supply between the panel and sauna heater depends on the heater type and output.
Refer to the panel's switch diagram
7014338 SYOK 40-3
OK 33 PU
x)
x)
Remote control
Control panel
n x 1.5 mm
2
Sauna
Sauna
heater
4 x 0.5 mm
2
3 1 4 5 6 2
1. Main switch
2. Thermostat
3. Signal light (heater)
4. Signal light (timer)
5. Reset button
6. Control fuse
1