2.6. If the sauna heater will not heat up
If the sauna heater will not heat up, please check that:
- the power is on;
- the main fuses of the sauna heater are intact;
- is there any error messages on the control panel. In case of an error message on the control panel,
please refer to the control panel instructions.
THE PERSON INSTALLING THE SAUNA HEATER SHOULD LEAVE THESE INSTRUCTIONS AT THE PREMISES
FOR THE FUTURE USER.
2.7. Preparing for sauna heater installation
Check the following before installing the sauna heater.
- The ratio of the heater's input (kW) and the sauna room's volume (m
3
). Volume recommendations are presented in
Table 1 on page 7. The minimum and maximum volumes must not be exceeded.
- The sauna room height must be a min. of 1900 mm.
- Uninsulated and masonry stone walls extend the preheating time. Each square metre of plastered ceiling or wall surface
adds 1.2 m
3
to the sauna room's volume.
- Check page 8 Table 2 for a suitable fuse size (A) and the correct diameter of the power supply cable (mm²) for the
sauna heater in question.
- Conform to the specified safe clearance around the sauna heater. Please refer to page 7.
- There should be enough room around the sauna heater controls for maintenance purposes. Also a doorway can be
considered as a maintenance area.
2.8. Installation
Follow the safety clearance specifications on page 7 when installing the sauna heater.
The sauna heater is a floor-standing model. The base must be solid, because the sauna heater weighs about 110 kg with
stones.
The sauna heater is levelled by the adjustable legs.
The heater is attached directly to the walls in a corner using the metal connectors supplied with the heater.
Components to secure the heater to the wall and floor are supplied with the heater.
Walls or ceilings must not be clad with fibre-reinforced plaster board or other light-weight cladding, because they may
cause a fire hazard.
Only a single sauna heater is allowed per sauna room.
Figure 2 Sauna heater installation
Installation and User Manual
Pikkutonttu Pure
6
1
2
1
2
3
3
- Secure the holder using three no 1 steel screws
4.2 x 9.5 mm on both sides of the heater.
- Place the heater on the holders
- Secure the heater to the wall using screws no 2.
Sauna heater's leg
Metal fastener for floor
mounting
Screw for adjusting the
sauna heater's leg
Screw for floor mounting
(not supplied with the
heater)
