Page 4
TMG-1200 Instruction Manual
4. RPM
Display
Displays the rpm's of the cold header and cold former in real time.
5. Batch
counter
A 3-digit counter which counts the number of times that the preset counter has counted up.
6. Parts
counter
An 8-digit preset counter which does not perform counting while detection is off.
7. Preset counter set point
Shows the set point of the preset counter.
8. Trend value sampling display
Indicates that sampling of Trend data, for absolute value detection, is not complete or
sampling is being performed.
9. External timing indicator
Indicates when the external timing is on.
10. Comment column
Shows the current fault or operational state.
11. ON/OFF button
The button to turn on or off fault detection by deviation. When fault detection is off, “OFF” is
shown on the set point display.
12. Batch counter reset button
Push this button to reset the batch counter to “0”.
13. Sampling button
Press Sampling button to start sampling Trend data for reference data during operation.
During sampling, “Sampling” appears on the screen.
14. Adaptive/Trend button
The button to select whether to cause the deviation display to show the absolute value or
mean value. Which of them is selected is indicated by “Adaptive” or “Trend” on the lower
side of #2 – Set point display. The button is factory set for mean value display.
15. Preset counter reset button
Push this button to reset the preset counter to “0”.
16. Preset counter select button
Push this button to set the point of the preset counter (refer to section “Operation of
Counter”).
17. Setup button
Push this button to change the set point (refer to section “Changing Preset Range).
18. Setup dial
Used to change the set point or to change settings in the system mode.
19. Contrast control
Used to adjust the contrast of the Liquid Crystal Display (LCD) screen. The contrast control
is factory adjusted. Readjust it when the screen is difficult to see.
