Library Editing Operation
Step 2
click library
in the main
page
Step 3 select
an empty
library
Step 4 click setting to
start editing library
Step 1 if there is no operation manual for the fixture, please connect the controller with the fixture, set the
fixture address and power up then you can begin editing library (when editing the library, we suggest
you use the default patch table to control the fixture)
Step 5 click the attribute
key and choose the
attribute want to edit,
and it will display a
green box
Step 8 after finishing step 6
and 7, click the attributive
key again to complete
operation. If want to edit
other attributes, repeat step
5 -8.
Step 9 set the total
amount of light
channels
Step 6-1 If hold a fixture operation
manual, can use wheel to input
attributive channel number. If want
to clean the attribute, just input 0
Step 7-1
set attributive start value: the
start value of flash fixture is 255
LED flash start value is 0
Light bulb and reset start value
are base on specific light
parameter
Other attributes do not need to
set
Step 7-2 set attributive close value: light
bulb and reset attributive close value are
base on specific light parameter. Other
attributes do not need to set.
Step 6-2-2 push attributive
fader to find attribute
location (see fader input
attribute value)
Step 6-2-1
select fixture
(see fixture
selection
operation)
Step 6-2 If there is no fixture operation manual, can
push the fader in preset area to find attributive
channel number (see manual operation)
Step 10 after all edits have taken place,
press enter key to complete and save
the library which will present in blue
When in fxture library editing status, press delete key can
clean the fxture library