HellermannTyton Autotool CPK hybrid, Operating Instructions Manual

Page: 15 / 47

Operating Instructions • CPK hybrid • 11-2021 • v04 • 106-29004
Settings in the display menu
15
AT 2000 CPK
001
1
2
3
f Access the settings, à "Accessing the settings" on
page 14.
f Press the Select button
2
.
f
The parameter set
3
is indicated with a blue border.
f
Press the Enter button
1
until the desired parameter
set
3
is displayed.
; The settings of the selected parameter set are displayed.
7 .3 Setting the force level
The setting corresponds to the force applied by the CPK
hybrid when binding, and it can be set from Level 1
(lowest force) to Level 5 (highest force).
AT 2000 CPK
001
1
2
3
f Press the Select button
2
.
f
The force level
3
is indicated with a blue border.
f Press the Enter button
1
until the desired force level is
reached.
; The force level
3
is indicated by the number of red
arrows.
7 .4 Setting the binding quality
The setting corresponds to the quality of binding and
it can be set from Level 1 (lowest quality) to Level 3
(highest quality). The higher the level the longer the
cycle time, so the bundle has more time to settle.
AT 2000 CPK
001
1
2
3
f
Press the Select button
2
.
f
The binding quality
3
is indicated with a blue border.
f Press the Enter button
1
until the desired binding quality
is reached.
; The binding quality
3
is indicated by the number of red
stars.
; The binding speed is indicated by the “speedometer
needle” position.
7 .5 Setting the loop diameter
The actual diameter may deviate from the set value as
the gearing and the state of the tool and processing
material have an impact on the binding.
Make sure that the binding does not produce a circular loop.
AT 2000 CPK
001
0.1
1
2
3
f Press the Select button
2
.
;
The loop diameter
3
is indicated with a blue border.
f
Press the Enter button
1
.
; The loop diameter value is activated.
f Press the Select button
2
.
;
The adjustable value is underlined.
f
Press the Enter button
1
several times until the desired
value is displayed.
f Press the Select button
2
.
; The selection jumps forward one digit.
f Repeat the setting until the desired values is reached.
7 .6 Setting the cutting mode
AT 2000 CPK
001
1
2
3
Flush cutting
f Press the Select button
2
.
; The strip section
3
is indicated with a blue border.
f
Press the Enter button
1
to activate flush cutting.
; No strip section is displayed when flush cutting is
activated.