BEFORE FIRST USE
Before use, remove all packaging materials and inspect the appliance for any damage. If there appears to be any
damage, please take the unit back to place of purchase for a replacement.
OPERATING INSTRUCTIONS
A.
Switching on the Appliance :
•
Allow the appliance to stand for a minimum of 4 hours after installation. Plug in the appliance and
switch on at the mains supply.
•
Set the thermostat control to the required setting as detailed in the Temperature Control section (3.2.).
•
Leave the appliance for approximately 4 hours for the correct temperature to be reached.
•
Place the appliance close to the wall with a distance not exceeding 75mm
B.
Temperature Control:
The temperature selector knob is located on the right hand side of the inner cabinet (see Description of the
Appliance on page 4). Please note that this unit does not have a freezer compartment. It has a freezer box which
maintains a cooling temperature.
•
Setting “0”: Unit Off
•
Setting “1”: Unit On –
Warmest Temperature
•
Setting “3” Normal Operation (adequate for most situations)
•
Setting “7”: Coldest Temperature
CAUTION: Select a suitable location for the appliance. Always choose a safe location in accordance to
the safely recommendations outlined.
.
NOTE: Before inserting the plug into a power outlet, make sure that the correct voltage being used
corresponds to what is indicated on the rating label, and that the socket has an earth facility.
NOTE: You may hear bubbling sounds when the refrigerant is pumped to the cooling system and
through the coils or tubing at the rear of the appliance. When in operation mode you may hear a
slight whirring sound or pulsating noise. The thermostat controls the operation of the compressor,
and you may hear a slight click as it cycles in and out.
IMPORTANT: During high ambient temperatures e.g. on hot summer days, it may be necessary to
set the thermostat to the coldest setting (position 7). This may cause the compressor to run
continuously in order to maintain a low temperature in the cabinet.
