Assembly Instructions
1.
Unscrew the butterfly nuts from the bottom side of the heater body.
2.
Feed the power cord through the centre of the base plate.
3.
Match the projection at the bottom side of the heater body with the indentation of the base plate.
4.
Secure the base plate by tightening the butterfly nuts.
5.
Run the cord through the power cord guide.
Operating Instructions
1.
Remove the unit from the box and take off any protective wrapping, and unwind the cord to its full
length.
2.
Place the heater on a smooth level surface at least 120cm away from any obstacles.
3.
Plug the power cord into a power outlet, do not locate the heater immediately below a power
outlet.
On/Off & Heat Settings:
Press the On/Off button – blue in colour, to activate the heater. The power ‘On’ indicator light will light up.
Select the heat by means of the suitable button ‘On 1/2/3’. The 1
st
& 3rd halogen tube will light up and
800W of power can be achieved. By pressing the other power switches simultaneously, the power settings
800W & 1600W can be achieved.
•
‘On 1/2/3’ pressed once is 800W
•
‘On 1/2/3’ pressed twice is 800W
•
‘On 1/2/3’ pressed three times is 1600W
Oscillation:
Press the oscillation switch to activate the oscillation function. If you want the heater to return to static
mode, press the switch ‘Off’.
Timer:
By pressing the timer button, you can set the appliance to turn On/Off on a timed basis. Times available are
0.5hr, 1hr, 2hr, 4hr & 7.5hr. Every press corresponds to 0.5hrs.
Hints & Tips
•
Do not overheat your home, in winter the temperature of a heated room should be between 18-21°C
•
Choose the right size heater for the room that you wish to heat.
•
Zone off the unoccupied rooms by closing doors, and curtains to limit heat loss.
•
Use draft stoppers where possible, to keep the cold air from filtering in under doors.
•
Avoid placing items, or sitting too close to the heater for optimal air flow.
