Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue Februa-
ry/2016
11
Installation of the guide rail insert
Press the guide rail insert into
the chamber of the guide rail.
Move the guide rail insert over all slat guiding
nipples towards the top. (A slight bending of
the guide rail insert eases the installation.)
All slat guiding nipples must
be placed inside the guide
rail insert.
The recess areas in the guide rail insert must
be at the bottom side. (Locking with pins of
the guide rail covering cap.)
Installation Instructions and Instructions for Use
12
Subject to technical modifications. – Date of Issue Februa-
ry/2016
Installation insect screen rail for integrated moscita
insect roller screen
The insect screen is already pre-assembled in the plaster base box.
With motor drive
Installation of the insect screen according
to the enclosed installation instructions for
outdoor blinds / exterior Venetian blinds.
(Chapter "Installation guide rail FUP70 /
FUP80 / FUP95
installation insect screen")
With crank handle drive
2
1
14,5
Do not remove the tear tape from the
guide rail!
Screw down the insect screen guide rail
laterally through the drilled holes to the
guide rail FUP95. Fix the insect screen rail
in such a way that it is flush with the lower
edge of the guide rail.
1 self drilling head screw / bore hole in the
insect screen rail
Legend
1
Tear tape
2
Self drilling head screw
ø4.2x22 mm
Installation Easy-Click see accompanying
installation instructions for outdoor blinds /
exterior Venetian blinds.
Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue Februa-
ry/2016
13
Commissioning / functional check
Extend and retract the unit in and out completely. When extending the unit
for the first time, make sure no one is in the operating radius or standing
below the unit.
Make sure that during the later operation the units can be extended freely
and without blockings. Do not extend the unit, if objects or persons are in the
operating radius of the awning. Please observe the safety instructions.
After the first extending check the fixing material and the construction ele-
ments for strength.
Automatic control devices or switches, that are not in the operator's field of
vision may not be used for test runs with motor drives.
We recommend the use of a test cable for the provisional operation of the
motor.
Check all settings.
Check all screwed connections for tightness.
Once again check the strength of the blind brackets on the
mounting base.
Attention!
An insufficient fastening of the mounting brackets can cause the collapsing
of the unit; there is risk of injury or danger to life!
Clean the elements (see maintenance instructions).
Pass these instructions as well as possible instructions of the motor, switch
and control manufacturer on to the user.
Brief the user, whereupon you provide comprehensive information on the
safety and user instructions of the system.
Have the correct design of the system as well as the installation and briefing
with the safety information confirmed in writing (see handover report).
Installation Instructions and Instructions for Use
14
Subject to technical modifications. – Date of Issue Februa-
ry/2016
Motor drive
With outdoor blinds in the front-mounted
system nova front-mounted box - side by side
the motor drive Geiger E06 is used as stand-
ard. This motor has the advantage that it
references on torque in the upper end posi-
tion and thus the package height remains the
same in the long run.
Change of the package / complete height:
Follow the enclosed operating instructions of
the motor manufacturer.
Removal
Switch the unit dead and take safety precautions against unintentional
switching on.
The removal is carried out in reverse order to the installation.
