Hella Gutmann Radar Kit III, Operating Instructions Manual

Page: 35 / 312

EN
Radar Kit III Working with the Radar Kit III
Adjusting the Rear Radar
5.3 Adjusting the Rear Radar
5.3.1 Attaching the Wheel Alignment Modules to the Rear Wheels
Proceed as follows to attach the wheel alignment module to the rear wheel:
1. Attach one wheel alignment module on the left and right rear wheel respectively.
NOTE
Ensure that the level bubbles of both wheel alignment modules are centred.
CAUTION
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
2. Align the laser module vertically to the floor by turning it.
3. Switch on the laser module of the wheel alignment module.
The laser point is indicated on the even ground surface.
4. Perform the steps 2 and 3 for the second wheel alignment module.
Now both wheel alignment modules are correctly attached to the rear wheels.
5.3.2 Positioning the Base Support at the Right Distance
and Parallel Behind the Vehicle
Proceed as follows to position the base support of the Rear Cam Kit I Basic at the right distance and parallel behind
the vehicle:
1. Connect the diagnostic device to the vehicle (see mega macs user manual).
2. Select >Diagnostics< in the main menu.
3. Select the system to be calibrated under >Basic settings< .
4. Position the base support behind the vehicle.
5. Read the correct distance in the diagnostic device.
NOTE
Regard the different reference marks depending on the individual manufacturer.
6. Measure the distance between the base support (front) and the center of the wheel hub (laser point on the ground
floor) with a tape and position the base support accordingly.
7. Perform step 6 for the second wheel alignment module.
Now the base support is positioned at the right distance and parallel behind the vehicle.
35