Hella Gutmann MT 56, Operating Instructions Manual

Page: 34 / 292

EN
Initial Start-Up MT 56
Inserting The MT 56 Into The mega macs 56
4 Initial Start-Up
This section describes the insertion of the MT 56 into the mega macs 56 and the MT-HV.
4.1 Inserting The MT 56 Into The mega macs 56
Proceed as follows to insert the MT 56 into the mega macs 56:
1. Push the release button of one of the modules at the mega macs 56.
The module releases from the module slot.
2. Draw the module out of the module slot.
3. Insert the MT 56 into the free module slot, pay attention that it locks into place.
4. Should you once not use the MT 56, then remove all connections/test leads from the MT 56 and disconnect the
mega macs 56 from voltage supply.
4.2 Inserting the MT 56 into the MT–HV
Proceed as follows to insert the MT 56 into the MT-HV:
1. Press the unlocking button of the module at the MT-HV.
The module releases from the module slot.
2. Draw the module out of the module slot.
34