Helipal SRD250 V3, User Manual

Page: 14 / 17

14
Copyright@2016 HeliPal.com. All Rights Reserved
FAQ
Lost connection with radio controller
–
AT9
If
you’re the drone cannot response to the radio controller stick travel, the connection between
radio controller and receiver may lost and you can try to re-bind them by following the procedure
below:
Press the switch inside the receiver twice with small screwdrivers to make LED indicator turns PURPLE to set the
control mode to D Bus Mode. ( Skip this step if it is default in Purple light )
Use the small screwdrivers to press and hold the switch inside the receiver until it is flashing with light in Blue and
Purple , Switch on the radio controller, it will start searching for available receiver. Receiver will stop flashing while the
bind process complete and the radio controller will the signal strength on the screen
Radio Controller Parameters – AT9
If you reset your radio controller (AT9) setting, you can apply the setting below:
1) Press and Hold the controller wheel (With wordings
“
PUSH
”) to unlock the manual. Press and Hold
Mode
Button to go into basic menu page
2) [STK-MODE] = 2 (Stick Mode)
[LockScreen] = 30s (Time to lock screen)