Helios 6T Series, Operation/Maintenance And Installation

Page: 22 / 27

INSTALLATION MANUAL – 2012
21
HUSA-EN-UL-REV 2.0 APR 16 2012
At least one WEEBlug assembly should be installed on each rail (more if rail splices are used). Slide a bolt
in the mounting slot of rail to the desired position, and then place the special steel flat washer on the bolt,
orient so the dimples will contact the aluminum rail. Slip the lug portion on top of the washer and install
standard flat washer, lock washer and nut. Tighten the nut until the dimples are completely embedded into
the rail and lug.
Even with splice rails, one single wire grounding is enough. Lay the equipment conductor in the lug and
torque bolt to 10 Nm. Then repeat the operation for the other WEEBlug assemblies. Once grounded to an
appropriate grounding electrode, the installation should look as above.