Operating
42
Energy Manager 1.3 - Instruction Manual
5.1.6
Load Submenu
Menu item
Display
Description
I/C
OpMode
One of the
modes:
Operating mode of the load
system. The mode is also
displayed in the main menu if no
error occurred.
init
Software module initializes
I
active
Load module is active
offline
Load is offline and will not be
monitored by the EM control
software.
I
standby
Load module is available.
I
error
Load module is in error status.
I
StateRpl
One of the
replies:
State reply. System answer on a
user command (CMD).
init
Software module initializes
I
offline
Load module is offline
I
run
Load module is available and
used.
I
test
Load module indicates that it is in
“Test mode”.
I
CMD
One of the
commands:
Command to be entered by a
user.
no command
No command in queue
I+C
go online
Start Load module
C
go offline
Stop Load module
C
go testmode
Set Load module to test mode
C
cancel
command
Cancel command in queue
C
Load
One of the
commands:
Command to be entered by a
user.
Disconnect load Switch load relay off manually
I+C
Connect load
Switch load relay on manually
I+C
Voltage
x.xx V
Load voltage [V]
I
Current
x.x A
Load current [A]
I
Power
x.x kW
Load power [kW]
I
P-Meter
xxxx kWh
Load energy [kWh]
I
Reset Counter*
Reset operating counters
C*
Error List
Number in
hexadecimal
format
All active events are displayed one
after another with their number
and a short text and can be
confirmed.
I+C
Legend:
*
Item is only displayed if the access level is service
I/C
Information/Command
Table 5-6 Load submenu