Getting Started
20
Energy Manager 1.3 - Instruction Manual
4.2.2
Installation Tools
For a standard installation the following tools are needed:
Standard tool box including:
Hex keys
Set of wrenches (metric)
Flathead screw driver set
Grippers
Wire cutter
Crimping tool
1 - 6 mm² duct tape
Digital multimeter
Clamp-on ammeter DC
4.2.3
How to Mount the Energy Manager
The Energy Manager is integrated in a free unit of a 19-inch-rack and
requires 3 height units.
The rack is fastened with wall or floor fasteners to prevent it from
tilting over.
Install the Energy Manager as follows:
1.
Take Energy Manager with both hands from the front side and insert it
into the rack.
If there is enough space for wiring from behind the backside of the Energy
Manager:
Fasten the device with2 screws on the left and on the right side.
If there is not enough space for wiring from behind the backside of the
Energy Manager:
Proceed with wiring the device (see
page 21). Only after wiring fasten the device as described above.
