Getting Started
Energy Manager 1.3 - Instruction Manual
21
4.3
How to Connect Sensors and Actuators
Through sensors the Energy Manager records all essential environmental
conditions and controls, regulates, and monitors the components of the
system.
In general, the Energy Manager is delivered in a customer specific
configuration. The configuration corresponds to the modules installed in a
site. If applicable, the Energy Manager ports are configured according the
standard configuration.
Calibration of sensors
All sensors are installed in the appropriate facilities and wired in
accordance with the specific conditions
Standard installation on USB flash drive
TIP
Modifications of the installation are performed via LAA and described in the
associated documentation.
4.3.1
How to Connect Cables and Plugs
If there is enough space left behind the Energy Manager, you can first
connect the cables to the wiring board and then attach the wiring board
to the 128 pin plug connector. If there is not enough space, you have to
pull out the Energy Manager with wiring board for about 20 cm and insert
the connections on the rear side from the front side.
Energy Manager installed in 19-inch rack
All connecting cables from sensors and actuators are transferred
to the rack
Side cutter, connectors, wire end ferrules
For all connections, proceed as follows:
1.
Cut cable to length with a side cutter.
2.
Insulate cable with wire end ferrules.
3.
Fix cable in the connector by tightening the screws.
When installing the standard configuration:
4.
Insert connector and cable to the wiring board according to
Table
4-2.
TIP
When installing a customer specific configuration or to change the default
settings, see LAA documentation and wiring diagram.
