HELGI - The Digital Courtyard
Via Artigiani 29/31 29020 Vigolzone (PC) Italy
E-mail: [email protected] | [email protected] | Web: www.HELGI-europe.com
14
Omnichart 36
USER MANUAL
Programming the timer
Set the simultaneous power supply to all sockets
1.
Press SET [C]. On the display [F] ON will appear.
2.
Press SET [C]. Press [A] to increase the playing time, [B] to decrease it. By setting the value “000” the sockets will always be active.
3.
Press SET [C] to save settings and ON [D] to activate charging. All LEDs corresponding to the different power strips [G] will switch on and
remain live for the duration set in point two.
4.
Turn the switch [E] to ON to start charging. On the display [F] the minutes remaining until charging is complete will be shown.
Set the cyclical power supply to groups of sockets
1.
Press SET [C]. The message ON will appear on the display.
2.
Press [B]. On the display [F] the message CYC will appear.
3.
Press SET [C] to set which power strips will be activated sequentially (from 1 to 4). For example, by selecting “3”, only 1, 2 and 3 strips
will be activated sequentially. Power strip 1 is the lowest.
4.
Press SET [C] to set the power duration of every strip by pressing [A] to increase the playing time, [B] to decrease it.
5.
Press SET [C] to save settings and ON [D] to activate charging. The LEDs corresponding to the power supply strips will light up in
sequence [G].
6.
Turn the switch [E] to ON to start charging. On the display [F] the minutes remaining to the completion of the sequence for that strip
will be shown.
All the operations described below must be performed in POWER OFF mode. Turn the switch [E] to OFF.
WARNING!
