Installation instructions Art. No
.
38177, 38178
Page 1 of 2
Status 06.2013
GB Installation instructions
LED Strip Set
Art. Nr.: 38177, 38178
Many thanks for deciding to buy our product.
Our lights are manufactured from robust, high-quality materials to provide you with attractive lighting. The articles
can be used indoors for decoration purposes.
Please read through installation and operation instructions carefully and keep these in a safe place.
We do not accept liability for damage to persons or property caused by non observation of the instructions,
improper handling or for unauthorized changes made to the product.
Technical data:
Article
Number
Description
Connection / Output
Degree of
protection
Protection
Class
38177
1
LED driver with
connection cable
Primary:100-240V ~, 50-60Hz, 0.5A
Secondary: 12V DC, 1,5A
IP 20
II
1
LED strip, L=2500mm
1 x 75 LED, red, 12V DC, 18W
IP 44
III
38178
1
LED driver with
connection cable
Primary:100-240V ~, 50-60Hz, 1.5A
Secondary: 12V DC, 3A
IP 20
II
1
LED strip, L=5000mm
1 x 150 LED, red, 12V DC, 36W
IP 44
III
Safety and warning notes:
The set may only be used after it has been taken out of the packaging. Take the product carefully out of
the packaging.
Keep packaging materials well away from children and pets.
Do not operate the product if the cable or the electrical parts are damaged. Repairs may only be done
by a specialist electrician.
Do not connect the LED set to other electrical appliances.
Disconnect the LED set from the power supply if you are not going to use it for a longer period of time or
a power supply is left unattended over a longer period of time.
Do not expose the LED set to extreme heat or exposed flames.
This product must not be modified or converted. Any modifications to the light will invalidate the
guarantee.
Care and servicing:
You must make sure that the power supply is disconnected before cleaning.
Use a dry, or slightly damp cloth for cleaning.
Never use chemicals, solvents, alcohol or abrasives for cleaning.
Disposal:
Old electronic equipment must be brought to public connection points and must not be disposed of as
household waste.
Montage:
Installation must be carried out only by a qualified electrician.
Decide on the location where installation has to take place.
Never place the product near sources of heat, heating ovens, for example..
Make sure that the base is solid enough to guarantee firm, proper fixing of the LED set. Observe the
respective processing regulations.
The LED strips and the connection components are provided with double-sided adhesive tape on the
rear side.
Never let the LED set hang down or swing.
Do not switch the product on in a rolled up state.
Do not cover the LED strip or LED driver with decoration material or film.
Do not use any sharp-edged tools for installation. Do not hit the product with a hammer or other tools.
Do not kink the LED strip or cable; ensure that the LED strip, cable and plugs are free of tensile and
torsion forces. Protect the LED set against possible damage.
Handle the LED set only in a power-free condition.
The connection points and the interfaces at the LED strip have to be provided with extra insulation when
they are used in a wet or damp environment (shrink-on sleeve or cold shrinking, for example)
The type designation plate must not be removed.
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
