1 of 2 | Dated 12.07.2016
GB Installation and operating instructions
LED pictures
Art. No. 34190 - 34194
These operating instructions belong exclusively to the products mentioned above.
You receive important notes for commissioning and handling the LED pictures.
Please therefore take care of these operating instructions, even if you pass this product on to
third parties.
It is important for this reason that you keep these instructions in a safe place to read later.
1. Introduction
Dear customer, Thank you very much for having decided to buy our product.
You have bought a Vollmer product, which has been built according to the latest advances in technology.
The LED picture fulfils the requirements of applicable European and national Directives.
In order to maintain the state of the product and ensure hazard-free operation, you as a user, must follow
these operating instructions!
2. Safety notes
Warranty claims become void in the event of damage, which are caused by not following these operating
instructions!
We accept no liability for consequential damage!
In the event of damage to the spotlight, it is strictly forbidden to start operating it.
Do not bring the picture into contact with extreme heat or naked flames.
The entire product should not be altered or converted. Alterations to the spotlight lead to the warranty
being rendered void.
Avoid staring into the activated LED!
The rating plate should not be moved
3. Use according to regulations
The LED picture is constructed for indoors use.
Light emitting diodes (LED) are used as lighting sources.
This LED guarantees high lighting strength with low power consumption.
4. Commissioning
1. Take the LED picture carefully out of the packaging.
2. Place the batteries into the battery compartment. Watch out for the correct polarity.
3. Position the LED picture at the desired wall while observing the safety and warning notes
and slide the switch to “ON”.
4. The luminant cannot be changed.
Note:
The lighting strength depends on the battery capacity.
