GENESIS ESP NZAust v1.4 MW
Page
1
of
3
GENESIS ESP LADDER TOWEL WARMER
For Warm Fluffy Towels
Operation
Your GENESIS ESP Towel Warmer uses only minimal electrical power - about the same as an
average light bulb. It will take approximately 20-30 minutes to reach maximum operating
temperature. GENESIS ESP Towel warmers are designed for continuous operation. NOTE: The
temperature of your towel warmer will vary with the ambient temperature of your room. A towel
warmer is designed to warm and assist the drying of towels and will normally operate at a
temperature that is too hot for the warmer to be grasped for an extended time. Refer to the
separate instruction brochure for operation instructions for the ESP feature
Locating Instructions
Detailed installation instructions are provided on the reverse side. The GENESIS ESP Ladder
Towel Warmer should be fixed through the wall cladding directly to studs or other suitable anchor
material. The towel warmer should be located in compliance with the AS/NZS 3000 Standard and
should not in any circumstances be located in the direct path of a water source (tap or shower
etc). GENESIS ESP towel warmers have an IP45 rating offering you the greatest flexibility to
safely locate the towel warmer in bathrooms or shower rooms in
Zone 1 -3
. All other electrical
fittings must also be compliant with the zone within which the warmer is being installed.
Electrical Installation
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical
supply, plug & switch location, and product location will comply with your local regulations.
New Zealand electrical wiring requirements stipulate that this appliance must be wired by a
registered electrician in accordance with current electrical wiring regulations. This appliance must
be fitted with an air gap phase isolation switch which isolates the phase & neutral in accordance
with local wiring regulations.
This product must be used in conjunction with a hard wired
switch
.
For complete temperature control a wall mounted dimmer switch (with “off” position) is
recommended.
Concealed Wiring Kit
A concealed wiring adapter kit is also included with this product. If you have access to the wall
cavity the adapter allows you to conceal the electrical flex for a more streamlined and visually
appealing installation.
Care and Cleaning
The polished stainless steel finish of your Towel Warmer is hard wearing and easily maintained.
Clean regularly with a soft cloth and non-abrasive cleaning agent.
Guarantee
The towel frame is guaranteed against defects due to faulty workmanship or materials for 5 years
from date of purchase and the ESP controller has a warranty of 12 Months. In the event of a
defect in the product, it should be returned with the sales receipt to the retailer from whom it was
purchased. Under the guarantee the defective article will be repaired or replaced at Heirloom’s
option – free of charge. Costs of disconnection, reconnection, and freight are the responsibility of
the owner, as is any damage arising in transit to and from servicing.
This guarantee does not cover:
a. Any damage to the product caused by misuse, neglect, accident, or in violation of the
manufacturer’s instructions, or
b. Any damage, loss or injury arising as a consequence of the use of the product.
Contact Us
We welcome your feedback on our products. You can view our full range of towel warmers on our
website and send us your comments about this product to [email protected]. Heirloom
International Limited, P O Box 204 235, Auckland 2161, New Zealand. www.heirloom.co.nz
