9
GASOLINE CHAIN SAW
7. OPERATING ENGINE
STARTING ENGINE
1
. Fill fuel and chain oil tanks respectively, and tighten caps
securely. (F7)
2.
Put the switch to “l” position. (F8)
3.
While holding the throttle interlock. push in the side throttle
lock button and release the throttle lever to hold it at the starting
position. (F9)
(1) Chain oil
(2) Fuel
(3) Switch
(4) Throttle lock button
(5) Throttle lever
(6) Throttle interlock
(7) Chock knob
4.
Pull out the chock knob to the closed position. (F10)
NOTE
When restarting immediately after stopping the engine, leave the
choke knob at the open position.
5.
While holding the saw unit securely on the ground, pull the
starter rope vigorously. (F11)
WARNING
Do not start the engine while hanging the chain saw with a
hand. The saw chain may touch your body. It’s very dangerous.
6.
When engine has ignited first, push in the choke knob and pull
the starter again to start the engine.
7.
Allow the engine to warm up with the throttle lever pulled
slightly.
WARNING
Keep clear of the saw chain as it will start rotating upon starting
of engine.
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed and see
if chain oil is scattered off as shown in the figure. (F12)
(1) Chain oil