Gasoline grass trimmer
Filing the blade
The blades are sharpened using a single cut flat file.
Sharpen all edges equally to maintain the balance of the blade.
Always stop the engine before starting work on any part of the cutting equipment. This continues
to rotate even after the throttle has been released. Ensure that the cutting equipment has stopped
completely and remove the cable from the spark plug before you start to work on it.
Trimmer head
Only use a trimmer head and trimmer cord that is recommended.
These have been tested by the manufacturer to suit a particular
engine size. This is especially important when a fully automatic
trimmer head is used. Only use the cutting equipment we
recommend!
Generally smaller machines require a small trimmer head and vice
versa. This is because when clearing using a cord the engine must
throw out the cord radially from the trimmer head and also meet
resistance from the grass being cleared.
The length of the cord is also important. A longer cord requires
greater engine power than a shorter cord of the same diameter.
Make sure the knife positioned on the trimmer guard is intact. This
is used to cut the cord to the correct length.
To increase the life of the cord it can be soaked in water for a few
days. This will make the line tougher and it will keep longer.
IMPORTANT INFORMATION
Always ensure the trimmer cord is wound tightly and evenly around the drum, otherwise harmful
vibrations will occur.
SAFETY INSTRUCTIONS
General safety instructions
IMPORTANT INFORMATION
The machine is only designed for trimming grass and brush cutting.
The only accessories to be used with the engine unit as a drive source are the cutting units we
recommend in the chapter
"Technical data".
Never use the machine if you are tired, if you have consumed alcohol, or if you are taking medicines
that can affect your sight, your judgement or the control of your body.
Use personal protective equipment. See the section
"Personal protective equipment".
Never use a machine that has been modified so that it no longer corresponds with the original
design.
Never use a machine that is faulty. Follow the maintenance, control and service instructions in this
Operator's Manual. Some maintenance and service actions should be carried out by trained and
qualified specialists. See the chapter
"Maintenance".
All covers and guards must be fitted before starting the machine. Check that the spark plug cap and
HT ead are not damaged, otherwise you could get an electric shock.
The machine operator shall ensure, while working, that no persons or animals come closer than 15
metres. When several operators are working in the same area the safety distance should be at least
double tree length, however, at least 15 metres.
WARNING!
