Heinner HWM-8014, Manual, Page: 44 / 100

www.heinner.com
43
XV. CLEANING AND MAINTENANCE
Solvents are forbidden to avoid damaging the washing machine, toxic gases and explosions.
Never use water to sprinkle and wash the washing machine.
It is forbidden that the detergents containing PCMX are used to clean the washing machine.
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance on the washing machine can extend its working life. The surface can be cleaned with
diluted non-abrasive neutral detergents when necessary. If there is any water overflow, use the wet cloth
to wipe it off immediately. No sharp items are allowed to strike the cabinet.
Notes: formic acid and its diluted solvents or equivalent are forbidden.
Clean Internal Drum
The rust left inside the drum by the metal articles shall be removed immediately with chlorine-free
detergents.
Never use steel wool.
Dispose a Frozen Washing Machine
When the temperature drops below zero and your washing machine gets frozen, you may:
1. Disconnect the power supply for the washing machine.
2. Wash the tap with warm water to loosen inlet pipe.
3. Take down inlet pipe and immerse it in warm water.
4. Pour warm water into washing drum and wait for 10 minutes.
5. Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Notes: when the washing machine is reused, make sure the ambient temperature is above 0 º C
Anti-freeze
If your washing machine is located in the room where it can get frozen easily, please drain the remaining
water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1. Close the tap.
2. Screw off the inlet pipe from tap and put its end into the container.
3. Start up any procedure except Wash or Drain procedure. Water will be drained out for about 40
seconds.
4. Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump