Heinner HPM-1000WH, User Manual

Page: 22 / 53

www.heinner.com 1000W, 50/60Hz, 220-240V
21
Meat mincer
1.
Assemble the blending pole, blade, clade tray and blade cover before blending.
Note: Let the location hole on the blade tray align with the pin, and make sure the
edge of blade toward the blade tray when assembling. Never assemble the blade
reversely.
2.
Assemble the blending pole support into the motor unit. Press the lock button
with thumb one hand, and hold the blending pole support with the other hand,
insert it into the hole of the unit and turn it anti-clockwise until it cannot move any
longer. Release the lock button, the blending pole support is fixed on the motor
unit, and the appliance can be used now.
Caution: make sure the appliance is unplugged when assembling.
3.
Put the funnel on the blending pole support.
4. Ensure that the unit is set at OFF position, then plug in power supply.
5. When the appliance operates normally, put the meat piece into funnel, then press
the food pusher to the lowest position.
Note: the meat piece should be able to put into the hole of funnel and no bone in
them.
6.
The max operation time per time shall not exceed 10 minutes and minimum 20
minutes rest time must be maintained between two consecutive cycles.
7. Place a clean container with proper size under blade cover to receive meat powder
come from the appliance.
8. Press the switch to“OFF”position immediately when blocking exists during
blending, let the unit turn clockwise, then release immediately, when the switch
resets to “OFF”position, if the blocking still exists, repeat the operations until the
blocking disappears. When finish blending, unplug to the power source.
9. Disassemble the blending pole support assembly: press down lock button properly
with thumb of left hand, turn the blending pole support assembly clockwise with
right hand then remove them.
Caution: ensure that the motor unit is unplugged when disassembling.