Heinner HOH-Y09WB, Manual

Page: 16 / 37

www.heinner.com 2000/2500W, 50/60Hz, 220-240V
15
V. ASSEMBLY
The heater is packaged with the feet unattached. You must attach them before operating the
heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright
position (feet on the bottom, controls on the top), any other position could create a
hazardous situation.
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable
and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided (see Fig 1), attach the
U-shaped bolt to the U-facing flange between first and second fins (near the front
cover)(see Fig 2).
3. To attach the castor mounting plate to the radiator body, you should insert the
threaded ends of the U bolt in the holes on the castor mounting plate (see Fig 3).
4
．
Screw the front wing nut to the front screw , same way , screw the back wing nut to
the back screw. ( see Fig .4)
Note: do not over tighten, which may cause the damage of radiator flange.
Note: the rear castors must be mounted between the end two fins.