Heinner HHVC-H7.4RD, Instruction Manual

Page: 17 / 37

www.heinner.com 45W, 220-240V~50/60Hz
IMPORTANT!

When the charging process is complete, which may take 6 to 8 hours for completely
discharged batteries, the device switches over to a trickle charge (maintenance
function) automatically. Nevertheless, in order to avoid possible damage to the
batteries, do not leave the appliance permanently connected to the power adapter.

Reconnect the appliance with the power adapter 4 when the suction power has
become noticeably weaker.
Note:
The hand vacuum cleaner can also be charged directly via the power adapter 4. For
this, remove the barrel plug 5 with a slight twist from the wall holder 3 and insert it
into the socket on the hand vacuum cleaner.
OPERATION
Warning!
The suction opening must always be open and unblocked. Blockages lead to
overheating and damage to the motor.
When in use, the LED indicator lamp 7 glows GREEN. When power is Low, it glows
Blinking GREEN. When there is out of power, it will blink fast for 3 seconds and power
off. Check to ensure that the on/off switch 6 slide back to the position "0" after this.
Tips:
1.
Make certain that the dust filter 9 is always inserted before using the appliance.
2. As the maximum, suck up only as much liquid as will fill the dirt container 0 to the
MAX mark.
3. Take the hand vacuum cleaner from the wall holder 3 or, if you do not use the wall
holder 3, remove the barrel plug 5 from the socket.
4. If required, place the appropriate nozzle into the suction opening:

the crevice nozzle 2, to clean narrow and difficult to reach locations.

the wet suction nozzle 1 to vacuum liquids up.
Note:
After you have vacuumed up liquids, immediately clean the dirt container 0. Otherwise
bacteria and microbes could form in it! Ensure that the dust filter 9/the dust filter bag
is completely dry before using the appliance again.
1. To switch the appliance on, slide the on/off switch 6 forwards.
2. When you have finished using it, slide the on/ off switch 6 to the rear.
Note:
Place the hand vacuum in the wall holder 3 and start the charging process when the
vacuum power has become noticeably weaker.