Heinner HFSC-V50LITGSL, Manual

Page: 56 / 132

www.heinner.com
55
Grill Burner Controls
Function Description
Turn the control clockwise to set the Grill.
CAUTION: Accessible parts may become hot while the grill is in use. Young
children should be kept away. As soon as you ignite the burner, place the grill heat
shield under the control panel. Then, lift the oven door up slowly until it stops at the
semi-open position (approximately 30°) and touches the heat shield. There is an oven
lamp inside the oven to illuminate the cooking area. Press the lamp button to switch
the lamp on or off.
Assembling the grill heat shield
Hold the heat shield with the warnings facing upwards. There are two small slots on
the right and left side of the rear edge of the shield, as shown in the figure.
There are two screws equipped with bushes under the oven control panel. Align the
bushes with the assembly slots so that the shield is located between the control panel
and the bush. Push the shield towards the appliance until it is firmly in its place.
Cooking
•
The grill burner creates a source of heat at a constant rate and cannot be adjusted
between the maximum and minimum positions. When switching the grill burner off, turn
the knob in a clockwise direction to the “0” position.
•
Place a tray on the shelf below the grid in order to collect the fat during grilling.
•
Place the wire grid on the topmost shelf, provided that the food does not touch the
grill burner.