Heinner HEM-1100CR, Instruction Manual, Page: 25 / 60

www.heinner.com 1100W, 50Hz, 220-240V
24
9. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten if
desired, sprinkle the froth with a little cocoa powder.
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the
steam knob to “O” position and make the coffee maker cool down for about half an hour
then poke the steam outlet for several times with a needle about 1mm in diameter, finally,
press down the coffee/steam button “ ” and turn on the steam knob to check if the
appliance can produce steam normally when the steam indicator (yellow) illuminates. Please
contact the service department if the appliance cannot produce steam after operate as
above.

FROTHING MILK/PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate,
water or tea.
Method:
1. Remove the removable tank and fill it with desired water, the water level should not
exceed the “MAX” mark in the tank. Then insert the tank into the appliance properly.
2. Then connect the appliance to power supply.
3. Press down the ON/OFF button “ ” to turn on the unit, the power indicator (red)
illuminates.
4. Press down the pump control button “ ” to the lower position, make sure the
coffee/steam button “ ” is at the higher position, the pump will pump water, when
there is water flowing out, close the pump immediately.
5. Press down the coffee/steam button “ ” to the lower position and wait for a moment,
the appliance begins to heat until the (yellow) lamp illuminates; it means the heating is
finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam
wand about 2 centimeters into the milk. Turn the steam knob in anti-clockwise slowly to
start making steam.
7. Then the desired result is got, you can turn the steam knob to the “O” position.