Heinner HEK-TF2200GR, Instruction Manual, Page: 4 / 31

www.heinner.com 1850-2200W, 50/60Hz, 220-240V
3
IV. USING INSTRUCTION
Attention: Before using the kettle for the first time, fill the kettle with cold water and boiled it
twice without any additives.
1. Fill the kettle with water. Do not overfill. Use the water level indicator.
2. Place the kettle on its base.
3. Electrical connection
•
Check whether the electrical voltage which you intend to use is the same as that of the
kettle. Details can be found on the label on the kettle’s base.
•
Only connect the kettle to a properly installed 220-240V 50/60Hz socket.
4. Switch the kettle to position ‘1’. The control lamp on the water indicator shows that the
water is being boiled.
4. Switch the kettle to position ‘1’. The control lamp on the water indicator shows that the
water is being boiled.
5. After boiling, the kettle switches off automatically.

Disconnect the kettle from the mains electricity supply.

Do not open the lid when pouring.

If the kettle is overfilled, boiling water may be ejected.

The kettle is only to be used with the stand provided.
6. This appliance is intended to be used only in household.
Special Safety Instructions for the Kettle

Use only cold water when filling the device.

The water level must be between the MAX. and MIN. marks.

Switch the kettle off before removing it from the base.

Always ensure that the lid is tightly closed.

The base and exterior of the kettle must not become wet.

Kettle body used must match with the kettle base.