6
Positioning the machine
When determining the place to put your machine on, take care to choose a place where you
can easily load and unload your dishes.
Do not put your machine in any location where there is the probability for the room
temperature to fall below 0°C.
Before positioning, take the machine out of its packaging by following the warnings located on
the package.
Position the machine close to a water tap or drain. You need to site your machine, taking into
consideration that its connections will not be altered once they are made.
Do not grip the machine by its door or panel in order to move it.
Take care to leave a certain clearance from all sides of the machine so that you can comfortably
move it back and forth during cleaning.
Make sure that the water inlet and outlet hoses do not get squeezed while positioning the
machine. Also, make sure that the machine does not stand on the electrical cable.
Adjust the machine’s adjustable feet so that it can stand level and ba
lanced. Proper positioning
of the machine ensures problem-free opening and closing of its door.
If the door of your machine does not close properly, check if the machine is stable on the floor
it stands; if not, adjust the adjustable feet and ensure its stable position.
Water connection
Be sure that the indoor plumbing is suitable for installing a dishwasher. Also, we recommend
that you fit a filter at the entrance of your place or apartment so as to avoid any damage to
your machine because of any contamination (sand, clay, rust etc.) that might be occasionally
carried in through the mains water supply or the indoor plumbing, and to forestall such
complaints as yellowing and formation of deposits after washing.
Water inlet hose
Do not use the water inlet hose of your old machine, if any. Use the new water inlet hose
supplied with your machine instead. If you are going to connect a new or long - unused water
inlet hose to your machine, run water through it for a while before making the connection.
Connect the water inlet hose directly to the water inlet tap. The pressure supplied by the tap
should be at a minimum of 0.03 Mpa and and at a maximum of 1 Mpa. If the water pressure is
above 1 Mpa, a pressure-relief valve should be fitted inbetween.
After the connections are made, the tap should be turned on fully and checked for water
tightness. For the safety of your machine, make sure to always turn off the water inlet tap after
each wash programme is finished.
Note: If models are marked with 25°, the water temperature may be max. 25 °C (cold water).
For all other models: Cold water preferred; hot water max. temperature 60 °C.
NOTE:
Aquastop water spout is available to your model. In case of using Aquastop, a dangerous
tension exists. Do not cut Aquastop water spout. Do not let it get folded or twisted.
V.
INSTALLATION
Summary of Contents for HDW-FS6006WE++
Page 58: ...www heinner com 57 ...
