Heinner HDCH-F3560RGBK, Manual

Page: 25 / 50

www.heinner.com 65W, 50Hz, 220-240V
24
FAULT POSSIBLE CAUSE SOLUTION
Light on, but fan does not
work The fan blade id jammed Switch of the unit. The repair must be
done by qualified service personnel only. The motor is damaged
Both light and fan do not
work Light bulb burn Replace the bulb with correct rating
Power cord looses Plug in to the power supply again
Serious vibration of the unit The fan blade is
damaged Switch of the unit and repair by qualified
personnel only
The fan motor is not
fixed Switch of the unit and repair by qualified
service personnel only
The unit is not hung
properly on the bracket Take down the unit and check whether
the bracket is in proper location
Suction performance not
good Too long distance
between the unit and
the cooking plane Readjust the distance to 65-75 cm
NOTE: Any electrical repairs to this appliance must conform to your local, state and federal
laws. Please contact the service centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the
unit.
VII. TROUBLESHOOTING