1200W, 50/60Hz, 220-240V
16
11.
Keep the appliance out of the reach of children.
12.
Never let the appliance run unattended.
13.
Switch the appliance off before detaching and install any accessory.
14.
Wait until moving parts have stopped running before you remove the parts
of the appliance.
15.
Never immerse the motor unit in the water or any other liquid, nor rinse it
under the tap. Use only a moist cloth to clean the motor unit.
16.
Do not attempt to grind bones, nuts or other hard items.
17.
Never reach into the cutter housing. Always use the pusher.
18.
Never operation the appliance continuously for more than 3 minutes at
600W. Accessories shall include instructions for their safe use.
19.
It shall warn of potential injury from misuse.
20.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been give supervision or instruction
concerning use of the appliance by a person responsible for their safety.
21.
Children should be supervised to ensure that they do not play with the
appliance.
22.
If the appliance is locked, please press Reversal button(REV). The meat
locked in cutter housing is untrodden, so the appliance can renew its usual
condition.
1.
2.
VI. USING INSTRUCTIONS
1.
Press the fasten button, hold the head and insert it into the inlet when inserting please
pay attention the head must be slanted as per arrow indicated on the top, see (fig.1),
then move the head anticlockwise so that the head being fastened tightly. (fig.2)
2.
Place the snake into the head, long end first, and turn to feed the screw slightly until it
is set into the motor housing (fig.3).
3.
Place the cutting blade onto the snake shaft with the blade facing the front as
illustrated (fig.4).If it is not fitted properly, meat will not be grinded.
4.
Place the desired cutting plate next to the cutting blade, fitting protrusions in the slot
(fig.5).
5.
Support or press the center of the cutting plate with one finger then screw the fixing
ring tight with another hand (fig.6). Do not over tighten.
6.
Place the hopper plate on the head and fix it into position.
