Heinner CA-220, Instruction Manual, Page: 18 / 50

www.heinner.com 800W, 50-60Hz, 220-240V
17
No. FAULT CAUSE SOLUTION
1 The ON light does not light up The appliance is unplugged Plug unit in
2 The coffee is not brewing F. The appliance is unplugged
G. There’s a power outage
H. The water reservoir is empty
I. The filter basket is not properly
inserted
J. The decanter is not placed all
the way in on the warming
plate
F. Plug Unit in
G. Wait for power to be restored
H. Check the water window
I. Insert filter basket correctly
J.
Place decanter correctly on
warming plate
3 The coffee maker only brews
water
There are no coffee grounds in the
filter basket Add the desired amount coffee ground
4 The coffee maker brews slowly The coffee maker needs cleaning Clean coffee maker as described in
“CLEANING AND MAINTAINING” section
5 The filter basket overflows E. The filter basket is not properly
inserted
F. The decanter is not placed all
the way in on the warming
plate
G. The decanter lid is not on
decanter
H. Too much coffee ground were
placed in the filter
I.
The decanter was removed
from the warming plate for
more than 30 seconds
E. Insert filter basket
correctly .
F. Place decanter correctly on the
warming plate
G.
Place lid on the decanter
H.
Remove filter, discard grounds. If
paper filter, replace. If permanent
filter, rinse. Begin brewing process
again
I. Turn off and unplug the unit. Allow
to cool, wipe up the spill. Do not set
hot decanter back on the wet
2. Insert glass carafe onto the warming plate.
3. Make sure filter (without coffee powder) and funnel are assembled in place.
4. Switch on the appliance and allow it to “brew” de-scaling solution.
5. After brewing one-cup solution, switch off the appliance.
6. Leave the solution stay for 15 minutes and repeat step 3-5.
7. Switch on the appliance and run off the solution until the water tank is completely
empty.
8. Rinse by operating the appliance with water at least 3 times.
VII. TROUBLESHOOTING